Motorola RAD4020ARB Installation Manual

Product Safety and RF Exposure
Compliance
CAUTION!
Before using this product, read the
!
operating instructions for safe usage
contained in the Product Safety and
RF Exposure booklet enclosed with
C a u t i o n
your radio.
ATTENTION!
This radio is restricted to occupational use only to
satisfy FCC RF energy exposure requirements. Before
using this product, read the RF energy awareness
information and operating instructions in the Product
Safety and RF Exposure booklet enclosed with your
radio (Motorola Publication part number
68P81095C99) to ensure compliance with RF energy
exposure limits.
Introduction
The antennas described in this section are supplied
with an appropriate antenna whip, coaxial cable and
connector, and mounting hardware. Mounting hard-
ware and installation is described for permanent vehi-
cle type mounting.
Table 1. Model Complement
Antenna Model
Roof Mount Models
RAD4012ARB
RAD4020ARB
HKAD4001A
RAE4022ARB
RAE4034ARB
RAF4021ARB
Refer to Table 1 for model identification. Figures 1
through 3 identify the component parts of the antenna.
Refer to the recommendations for antenna location
paragraph at the end of this instruction section for
safety information.
Motorola, The Stylized M Logo, and Intelligence Everywhere are
registered trademarks of Motorola, Inc.
Copyright © 2000, 2002 Motorola, Inc. All Rights Reserved.
Frequency Range (MHz)
150.8-162
162-174
216-225
403-430
450-470
806-870
Mobile 1/4-Wave Antennas
Installation
Mounting Hardware Installation – Roof
Mount
General
The installation procedure which follows is for a typi-
cal passenger car. The procedure may vary slightly
with the type of vehicle on which the antenna is to be
installed. Generally speaking, however, the procedures
outlined are of a universal nature.
ANTENNA ONLY
ROD WITH
CHROME NUT
MOTOROLA ANTENNA
(ROD)
PART NO. MODEL NO.
01-80352A07 01-83938B03 RAD4012ARB
01-80352A08 01-83938B04 RAD4020ARB
01-80305K05 01-83938B12 HKAD4001A
01-80352A11 01-83938B06 RAE4034ARB
01-80352A90 01-83938B11 RAF4021ARB
Figure 1. Whip Parts Identification
The antenna should be mounted on a flat
metal roof of .020 to .040 inch thickness.
1. First, select a location for the antenna as near
the center of the roof as possible.
2. The headlining may be probed with the fin-
gers to make sure that all points of obstruction
.
are avoided
Installation Procedure Single Wall Construction
1. Locate the center of the roof by careful mea-
surement, remove the headlining as necessary,
*6880360B49*
Roof Mount
FREQ. RANGE
(MHz)
150.8-162
162-174
216-225
450-470
806-870
NOTE
6880360B49-A