Graco 2794 Quick Start

Quick Start
Product Instruction Manual
1 Remove battery door.
R
1 Plug AC adapter into nursery unit.
Monitoring 2 Rooms
Room 1
Room 2
1 Place nursery units in desired
rooms.
Monitoring 1 Room Only
1 Place nursery unit in desired
room.
2 Install battery pack.
2 Remove battery door (optional).
Power Button
2 Press the power button on units.
Make sure AC adapter is properly
connected.
Power Button
2 To use only one nursery unit,
press power button on both parent
and nursery unit(s).
OR
3 Connect AC adapter to docking
station (Place unit on docking station)
or to parent unit. Charge battery for
16 hours before using.
3 Insert batteries (optional).
Batteries not included.
Room
1
2
Side views of a parent unit
3 Push room unit switch to room 1,
on first parent unit. While pressing the
timer button, use volume up/down, to
select desired monitoring time. Repeat
for room 2. Repeat instructions to setup
second parent unit if desired.
Room
1
2
3 Select unused room. While pressing
the timer button, press volume down,
to turn off timer for that room.
MODEL# 2794
4 Parent unit is ready for use.
Repeat steps 1-3 for other parent unit.
4 Replace battery door and tighten
screw. Repeat steps 1-3 for other
nursery unit.
2 min
1 min
Nursery
Nursery
30 sec
Unit 1
Unit 2
10 sec
OFF
4 Parent unit will begin searching for
each nursery unit in use. Once located,
the parent unit will alternate listening
between nursery units, based on
selected times from previous step.
2 min
1 min
Nursery
Nursery
30 sec
Unit 1
Unit 2
10 sec
OFF
4 Parent unit will begin searching for
the nursery unit in use. Once located,
the parent unit will begin monitoring
the nursery.
©2007 Graco ISPM020AA 5/07