Revolabs HD Dual Channel System Setup Manual

Advertisement

Revolabs HD Single / Dual Channel System — LifeSize Team MP Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs HD Single or Dual Channel System to a LifeSize Team MP video codec.
It is important to carefully follow these instructions in order and completely.
Note:
Otherwise your Revolabs Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs HD Single or Dual Channel System
2. LifeSize Team MP video codec
3. QTY 1 3.5mm unbalanced male connector to dual RCA male connector
cable*
* 07-35MUTODRCA-01 6' 3.5mm unbalanced male connector to dual RCA male
connector cable available from Revolabs

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HD Dual Channel System and is the answer not in the manual?

Questions and answers

Summary of Contents for Revolabs HD Dual Channel System

  • Page 1 This setup guide will guide you through the steps needed to properly connect a Revolabs HD Single or Dual Channel System to a LifeSize Team MP video codec. It is important to carefully follow these instructions in order and completely.
  • Page 2 Connecting the Cables 1. Insert the unbalanced 3.5mm male connector to the CH 1 OUT port on the Single or Dual Channel System. If using a Single Channel, DIP Switch #1 should be “OFF”. If using a Dual Channel, DIP Switch #1 should be “ON”. 2.

This manual is also suitable for:

Lifesize team mp

Table of Contents