Advertisement
the battery could wholly deplete without a warning of the battery condition being sent to the panel. If the LED on
the device appears dim or does not turn on when a button is pressed, it is a warning that the battery may be low or
depleted and should be replaced. To ensure proper functionality, test the device weekly.
Steps for replacing the battery:
1. With a key or small screwdriver, press the black tab located at the bottom of the remote (Figure 1) and slide the
chrome trim off.
2. Carefully separate the front and back piece of plastic to reveal the battery.
3. Replace with a CR2032 battery ensuring the + side of the battery faces up (Figure 2).
4. Re-assemble the plastics and ensure they click together.
5. Ensure the notch in the chrome trim is aligned with the back of the plastic. It will only go on one way (Figure 3).
Specifications
Frequency
Battery
Battery Life
Operating Temperature
Operating Humidity
Compatibility
Weight
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by UTC Fire and Security could void the user's authority to
operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est
soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit
accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
466-xxxx • REV A • 28NOV17
433.65MHz
3V Lithium CR2032
5 years under normal operating conditions
10°-120°F (-12°-49°C)
5-95% RH non condensing
Ultrasync (Self Contained Hub and Modular Hub)
42.5g
© 2017 United Technologies Corporation. All rights reserved.
Advertisement
