Advertisement
Quick Links
Advertisement
Related Manuals for popstrukt Breve
Summary of Contents for popstrukt Breve
- Page 1 Breve Coffee table ASSEMBLY INSTRUCTIONS...
-
Page 2: Tools Required
The Basics. First of all, don’t panic, we’ve got you covered with simple step by step instructions to help you pop-up your new piece painlessly. We know a sack of bolts looks daunting but lets start with the basics. ASSEMBLY RATING: ASSEMBLY TIME: 90 minutes PEOPLE REQUIRED:... - Page 3 Overview The Breve comes in flatpack. You will have to mount the base, then assemble the trunk onto the base section before placing the lid onto the unit and finally assembling and installing the drawers.. Supplied AMOUNT 2A/3A STEP 2C/3C...
- Page 4 Fix Base and feet to bottom. HARDWARE 1A + 1B - Do this on a carpet or soft suface. 1A - Place the base on the bottom side of the base board. Note that the bottom piece (base baord) is a mirror image of the top board. The existing holes should face away from the face you are mount- ing onto.
- Page 5 Assemble trunk. HARDWARE 2A - 2C - Insert and tighten fasteners. The trunk assembly requires some focus and remember to think ahead when putting the pieces into place. Step 2A - Insert all the fastner screws and dowels on all 5 pieces starting with the base board. Step 2B - Interlock the pieces.
- Page 6 Insert lid onto trunk base. HARDWARE 3A - 3C Step 3C will tighten lid. Step 3A - Insert all of the tightening screws into the lid. Step 3B - Place the lid onto the trunk base. You can manipulate the srews and dowels to fit. Step 3C - Insert and fasten all the tightening caps.
- Page 7 Assemble Drawers HARDWARE 4A + 4B - Use of powertool recommended. 4A - Assemble the drawers one corner at the time by aligning the pre drilled holes. The drawer stopper should face the handle side. 4B - Attach handle/front boards. Don’t tighten yet as this can be done at the end when to ajust posi- tion NOTE: make sure the drawer screws are countersunk to prevent them from...
- Page 8 Insert Drawers HARDWARE 5A 5 - The drawers are simply inserted into the sliding rails and pushed in all the way to the back untill you hear a click. The drawers might move with friction at first but opeing and closing them repeat- edly will improve the smoothness.
- Page 9 Adjust drawer height and friction. HARDWARE 6A - Use hand tools. 7A - The drawers can be adjusted by moving the drawer screws to the vertical slots, do this one by one and before tightening them make sure the hight is correct. ASSEMBLY INSTRUCTIONS...
- Page 10 YOU’RE ALL DONE, ENJOY! Share a pic of your new piece. Popstrukt Furniture @Popstrukt_com @popstrukt_com Popstrukt Furniture ASSEMBLY INSTRUCTIONS...
Need help?
Do you have a question about the Breve and is the answer not in the manual?
Questions and answers