PTAC WALL SLEEVE Installation Instructions

The wall sleeve must be installed before the air conditioner or heat pump chassis can be
When 230/208 volt units are to be installed, the power
supply may be either cord connected or permanent
wiring. Permanent wiring may be done through the hard
wire junction box, or the accessory subbase.
When 265 volt units are to be installed, the power supply
must be permanent wiring. Permanent wiring may be
done through the accessory hard wire junction box, or
the accessory subbase. An exposed cord connection
on 265 volt units is not permitted.
The subbase accessory includes leveling legs. If added
wall sleeve support is required and the subbase is not to
be used an accessory leveling leg kit may be installed.
KIT ACCESSORIES ..................................................................................................... 2
D K
RAIN
S
UBBASE
PRE-INSTALLATION CONSIDERATIONS .................................................................. 3
O
UTDOOR
WALL SLEEVE INSTALLATION .................................................................................. 4
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the product better than the customer. This
Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual. Pay special
attention to all safety warnings. Often during installation or repair it is possible to place yourself in a
Remember, it is your responsibility to install the product safely and to know it well enough to be able to
Safety is a matter of common sense...a matter of thinking before acting. Most dealers have a list of
The precautions listed in this Installation Manual are intended as supplemental to existing practices.
However, if there is a direct conflict between existing practices and the content of this manual, the
Part No. A3495105
Printed in USA
PTAC W
I
NSTALLATION
set in place. Read the instructions thoroughly before proceeding.
....................................................................................................... 2
IT
, L L , M
EVELING EGS AIN
E P R
NCLOSURE ANEL
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION
includes all safety precautions and related items.
position which is more hazardous than when the unit is in operation.
instruct a customer in its safe use.
specific good safety practices...follow them.
precautions listed here take precedence.
S
ALL LEEVE
I
NSTRUCTIONS
Contents
D , H
UCT AND YDRONIC
.............................................................. 3
EMOVAL
Made in USA
H K ........................ 2
EAT ITS
August 2005