Pairing A Bluetooth Device; Troubleshooting - ION PATHFINDER 2 Quick Start Manual

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Pathfinder 2. * If you have previously connected to another Bluetooth device,
Pathfinder 2 will reconnect. To disconnect pairing if the Bluetooth icon is lit solid, press
and release the Bluetooth button.
3. Press and release the Bluetooth button to pair to a Bluetooth device.
4. Navigate to your Bluetooth device's setup screen, find "Pathfinder 2" and connect. *
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
5. To disconnect pairing while the Bluetooth icon is lit solid, press the Bluetooth button. *
6. To connect to another Bluetooth device, repeat step 3.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0 or higher.
* Tip: Press and hold the Bluetooth button to enable or disable voice prompts.

Troubleshooting

If the sound is distorted: Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Pathfinder 2 using the
Master Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If there is poor AM reception: To adjust AM reception, move the entire unit.
If you can't hear the microphone over the music volume: Turn down the music volume
from your source.
If you can't play music from a flash drive: The USB port is only for charging USB devices.
6