Installation - Sherwood Newcastle R-325 Operating Instructions Manual

Please make the following connections (where applicable).
Notes!
– SWITCH OFF THE RECEIVER BEFORE MAKING ANY
CONNECTIONS.
– Do not connect the receiver to the AC outlet when making
connections.
– Be sure to connect the white plugs to the L (left) and the
red plugs to the R (right) jacks when making connections.
FM
(INDOOR ANTENNA)
300 ohm
feeder
SUPPLIED ADAPTOR
CONNECTIONS
1.FM INDOOR ANTENNA
Connect the supplied antenna to the FM antenna
terminals, as shown.
Change the position of the antenna until you get the best
reception of your favorite FM stations.
FM OUTDOOR ANTENNA
A 75Ω outdoor FM antenna may be used to further
improve the reception.
Disconnect the indoor antenna before replacing it with the
outdoor one.
2.AM LOOP ANTENNA
Tune in your favorite AM station and position the loop
antenna for best reception. Try other stations and find the
position that gives best overall reception. When this unit is
mounted in a rack or placed on a shelf with insufficient
space behind, hang the antenna on a wall in the direction
which gives best reception.
3.SYSTEM GROUND TERMINAL
When using a turntable, connect the ground lead from
your TURNTABLE to this terminal.
4.AUDIO IN/OUT
– PHONO IN – input jacks for connecting a turntable.
Connect these jacks to the output jacks of a turntable
with MM (Moving Magnet) type cartridge.
– CD IN – input jacks for connecting a Compact Disc
player.
Connect these jacks to the OUTPUT jacks of the CD
player.
CONNECTIONS
FM
(OUTDOOR ANTENNA)
AM
1 2 3 4 7 12
GND GND
REAR SPEAKERS(4Ω)
REAR SPEAKERS(4Ω)
PHONO PHONO
R R
+ +
CD CD
AM AM
LOOP LOOP
MULTI
MULTI
ROOM -
ROOM -
AUX/TV AUX/TV
FM FM PLAY PLAY DIGI-LINK
DIGI-LINK
75Ω 75Ω
VIDEO VIDEO TAPE TAPE
MON. MON.
MON.
MON.
REC REC
OUT
OUT
ANTENNA ANTENNA
L L
PLAY PLAY
VCR1 VCR1
R
R
REC REC
L L R R
SUB SUB FRONT FRONT
FRONT FRONT CENTER CENTER
WOOFER
WOOFER PRE-OUT PRE-OUT MAIN-IN
MAIN-IN PRE-OUT PRE-OUT
PRE-OUT PRE-OUT
5 6
Important note for connecting equipment that does
not have IN/OUT markings on the input and output
jacks:
R-325 Device to be connected e.g. cassette deck.
PLAY → PLAY or OUT
REC →
REC or IN
8 9 10 13
CENTER SPEAKER(8Ω) CENTER SPEAKER(8Ω)
L L
+
+
AC INPUT AC INPUT
~120V /60Hz
~120V /60Hz
2.3A
+ + 2.3A
- - - -
FRONT SPEAKERS(8~16Ω) FRONT SPEAKERS(8~16Ω)
R R L L
AC OUTLET AC OUTLET
A A
SWITCHED SWITCHED
-120V/60Hz -120V/60Hz
1A MAX 100W 1A MAX 100W
+ + - - + +
- -
B
B
REAR REAR
PRE-OUT PRE-OUT
11 14
– AUX/TV IN – input jacks for connecting the fixed audio
output jacks of a TV set or any other source you want to
hear; an additional CD player or a cassette deck.
– TAPE MON PLAY/REC – play and rec jacks for
connecting a cassette deck, a Digital Compact Cassette
deck or another digital recording device.
Connect the PLAY jacks to the PLAY or LINE OUTPUT
jacks of the deck.
These jacks may also be connected to the LINE
OUTPUT jacks of an audio processor such as an
optional graphic equalizer or a Digital Signal Processor.
Connect the REC jacks to the REC or LINE
jacks of the deck.
These jacks may also be connected to the LINE INPUT
jacks of an audio processor such as an optional graphic
equalizer or a Digital Signal Processor.
– VCR 1 PLAY/REC – play(input) and rec(output) jacks for
connecting the audio OUTPUT and INPUT jacks of a Hi-Fi
stereo VCR.
Connect the PLAY jacks to the AUDIO PLAY or
OUTPUT jacks of the VCR.
Connect the REC jacks to the AUDIO REC or INPUT
jacks of the VCR.
Note : The audio and video inputs and outputs of the VCR
must be connected to allow the
VCR 2/CAMCORDER inputs on the front of the
receiver to be used for recording input.

INSTALLATION

SER. NO SER. NO
MODEL NO. R-325 MODEL NO. R-325
AUDIO/VIDEO RECEIVER
AUDIO/VIDEO RECEIVER
I
NPUT
3