Sherwood Newcastle V-756 Operating Instructions Manual page 35

Continued
Repeat the above steps 2 and 3 to adjust each speaker setting correctly.
4
Notes :
The delay time(s) is (are) automatically adjusted, based on the distance entered.
When PRESENT is selected for the rear center speaker type, the rear center signal is extracted from the
rear left and right signals and reproduced during playback of 5.1 CH program sources such as Dolby Digital,
DTS and MPEG Multichannel.
When the front L/R, front center and rear L/R speakers are all set to LARGE , the subwoofer is automatically
set to LFE .
When the front L/R speakers are set to SMALL , the front center and rear L/R speakers are all set to
SMALL (or "NONE") and the subwoofer is set to MIXED automatically.
When the front center or rear L/R speakers are set to LARGE , the front L/R speakers cannot be set to
SMALL .
When the rear L/R speakers are set to "NONE", the rear center speaker is automatically set to "NONE".
When the front center or rear L/R speakers are set to NONE , the sound intended for these speaker(s) is
redirected to other speakers.
When the speaker(s) is (are) set to SMALL , the low frequency range of the speaker(s) is redirected to other
speaker(s) which is (are) set to LARGE or MIXED .
■When selecting the TEST NOISE (TEST TONES)
T E S T N O I S E
F R O N T L E F T
F R O N T C E N T E R
F R O N T R I G H T
R E A R R I G H T
R E A R C E N T E R
R E A R L E F T
S U B W O O F E R
R E T U R N : ⊃ S E T U P :
Tilt the CURSOR/ENTER button upward or downward to select the preferred channel, then tilt the
1
CURSOR/ENTER button left or right to adjust its level as preferred.
Repeat the step 1 until the sound level of each channel is heard to be equally loud.
2
S E L E C T : +
0 d B
0 d B
0 d B
+ 3 d B
No test
N / A
noise
- 3 d B
+ 5 d B
F I N I S H
RC
The test noise will be heard from the speaker of
each channel for 2 seconds.
When the speaker type is adjusted to NONE ,
N/A is displayed at its channel, and the test noise
will skip that channel.
RC
35