Page 4
Figure 2: Back view 1. RJ45 ports (RS232) 8. WIFI/BT antenna connector 2. 6.3mm DC power jack 9. LED indicators (12VDC-Output) 10. RJ45 port (RS232) 3. Microphone jack 11. USB 2.0 Mini-B 4. Earphone jack 12. MDB port 5. Ethernet port 13.
Page 5
PAX TECHNOLOGY LIMITED Figure 3: View from all angles...
Page 6
2) Recommended Device Connection Figure 5: Connecting the IM300 to amagnetic-strip/IC card reader...
Page 7
Figure 6. The IM300 both controls and powers the magnetic-strip/IC card and contactless card reader. If the IM300 is used to link to devices aside from the IM500 and IM700, the user must first confirm that the software and hardware for the connection is suitable.
Page 8
Other professional installation requirements: NO.8 SMA connector is designed for the WIFI/BT antenna connection. The user can connect the antenna to IM300 via the port. The antenna should be installed as high as possible on the unattended machine.
Page 9
Switch off: Disconnect the IM300from whatever power terminal it is connected to. 2) Using the Keypad Figure 7: IM300 keypad The IM300 contains a standard numeric keypad; 1 through 9 incrementing through three rows, with 0 being in the bottom...
Page 10
center fourth row (center-left in Figure 7 because of the functional keys in the last column). The functional keys from top to bottom are: cancel, clear, help, and enter. The two up and down navigational keys are respectively on the bottom center-right and the bottom far-left.
Page 11
2) Make sure the terminals the power or MDB cables connect to provide the appropriate voltages at the proper pins. 3) Do not insert unknown materials into any port on the IM300, this may cause serious damage to the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. FCC WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC...
PAX TECHNOLOGY LIMITED FCC CAUTION Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility...