Page 1
& operating instructions and washing guidance Automatic washing machine WMXD 760 W WMXD 760 S...
Page 2
Dear Customer, We hope that your product which has been manufactured in modern facilities and passed through a strict quality control procedure will give you the best results. Therefore, we advise you to read through this manual carefully before using your product and keep it for future reference.
1 Your Washing Machine Overview Specifications 2 Warnings General Safety First Use Intended use Safety instructions If there are children in your house... Electrical connection 3 Installation Removing packaging reinforcement Opening the transportation locks Appropriate installation location Adjusting the feet Connecting to the water supply.
Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant standards. Depending on operational and environmental conditions of the appliance, values may vary. WMXD 760 W WMXD 760 S 230/50 2200 1600...
Warnings Please read the following information. Otherwise, there may be the risk of personal injury or material damage. Moreover, any warranty and reliability commitment will become void. General Safety • Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below your machine may cause electrical parts to overheat.
remain in an undamaged state. • Fit the draining hose to a washbasin or waste system securely before starting up your machine. There may be a risk of being scalded due to high washing temperatures! • Never open the door or remove the filter while there is still water in the drum.
Page 8
cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.
Installation Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Opening the transportation locks C Transportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged! 1.
2. Adjust them until the machine stands level and firm. 3. Important: Tighten all lock nuts up again. Connecting to the water supply. Important: • The water supply pressure required to run the machine must be 1-10 bar (0,1 – 10 MPa). (Practically, it is necessary to have 10 –...
Your house may be flooded if the hose falls out of its housing during water discharging. • The hose should be attached to a height of at least 40 cm, and 100 cm at most. • In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water...
Initial preparations for washing Sorting the laundry • Sort the laundry according to type of fabric, color, and degree of soiling and permissible water temperature. Always follow the advice on the garment labels. Washing water Wash with Non machine- washable temperature sensitive, short programs.
Following weights are given as examples. Laundry type Bathrobe Napkin Duvet cover Bed Sheet Pillowcase Tablecloth Towel Evening gown Underclothing Men’s coveralls Men’s shirt Men’s pajamas Blouse Loading door The door is locked during program operation. The door can be opened after some time following the program end.
Page 14
Detergent quantity for prewashing 1/2 measure for main 1 measure washing an additional with hard water 1/2 measure Softener Put the softener into the softener compartment of the detergent dispenser. • Use the proportions recommended on the packet. • Never exceed the (> max <) level marking;...
Selecting a program and operating your machine Control Panel Figure 2 1 - On/Off button 2 - Program follow-up indicator 3 - Display 4 - Program selection knob 5 - Start/Pause/Cancel button 6 - Auxiliary function keys 7 - Time delaying buttons (+/-) 8 - Spin speed adjustment button 9 - Door open button (according to your machine’s model)
Turning the machine on Plug in your machine. Turn the tap on fully. Check if the hoses are connected tightly. Place the laundry in the machine. Add detergent and softener. Press the “On/Off” button. Program selection Select the appropriate program from the program table and the following washing temperature table according to type, amount and degree of soiling of the...
to “Synthetic” program. It must be used for clothes for which sensitive washing is recommended. • Duo You can use this program to wash cottons and synthetics together. There is no need to sort them. • Xpress Super Short Suitable for slightly soiled and little amounts of laundry.
Program selection and consumption table Programme Cottons Hygiene Cottons+Quick Cottons 60** Cottons Super Short Synthetics Synthetics Delicate Woollens Hand wash/Silk Hand wash • : Selectable * : Automatically selected, not cancellable. **: Energy Label programme (EN 60456) Water and power consumption and programme duration may differ from the table shown, subject to changes in water pressure, water hardness and temperature, ambient temperature, type and amount of laundry, selection of auxiliary functions, and fluctuations in the supply voltage.
Auxiliary functions Auxiliary Function Selection Buttons Select the required auxiliary functions before starting the program. C Some combinations cannot be selected together. Auxiliary function selection If an auxiliary function that should not be selected together with a previously selected function is chosen, the first selected function will be cancelled and the last auxiliary function selection will remain active.
light will light up according to the selected program. Changing the delay time If you want to change the time during the countdown: 1. Press “Start/Pause/Cancel” button. The “:” in the middle of the screen will stop flashing. 2. Press “Time Delay” (+/-) button to adjust the desired time delay.
End of program When the program is finished, the symbols of the relevant steps will remain lit up and the auxiliary function, spin and temperature data selected at the start- up of the program will remain selected. Ending the program through cancelling “Start/Pause/Cancel”...
Quick instructions for daily use Preparation 1. Turn the tap on completely. Check if the hoses are connected tightly. 2. Place the laundry in the machine. 3. Add detergent and softener. Starting 1. Press the “On/Off” button. 2. Select the programme and the temperature.
Cleaning and care Detergent drawer Remove any powder residue buildup in the drawer. To do this; 1. Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine. C If more than a normal amount of water and softener mixture starts to gather in the softener compartment,...
• If the filters are very dirty, you can pull them out by means of pliers and clean them. • Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under streaming water. •...
Page 25
If your product is not supplied with an emergency drain hose, do the following as shown in the figure below: • Place a large container in front of the filter to receive water flowing from the filter. • Loosen pump filter (anticlockwise) until water starts to flow out of it.
Troubleshooting Problem Cause Machine may have Program switched to self cannot be protection mode due to started or an infrastructure problem selected. (such as line voltage, water pressure, etc.). There may be some water in your machine when you Water in the receive it.
Page 27
The water being taken Improper position of the in is directly drain hose. discharged. No water can This is not a problem. The be seen in water level is not visible the machine from the outside of the during machine. washing.
Page 28
In the case of a paused countdown while taking in water: Timer will not countdown until the machine is filled with the correct amount of water. In the case of a paused countdown at the heating step: It continuously Time will not count washes.
Page 29
- Using insufficient amount of detergent for a long time, - Washing at low Washing temperatures for a long performance is time, poor: - Using insufficient Laundry turns amount of detergent for gray hard waters (soil can stick to the laundry), - Using excessive amount of detergent (detergent can stick to the laundry).
Page 30
The amount, brand and storage conditions of the detergent used might not be appropriate. Detergent might have been put in the wrong compartment. Machine filter may be It does not clogged. rinse well. Drain hose may be folded. Check the drain hose. Intermediate spins may be skipped.
Page 31
You may have added too much softener. The detergent dispenser might be problematic. Water may be siphoned (pulling the softener into the washer early) during the fill or rinse cycles. There might be problems with the valves.
Guarantee Your new Beko product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect.
Should you experience any difficulty in obtaining service please contact the Beko Customer Help-Line. Tel: 0870 774 1050 e-mail:service@beko.co.uk 0870 241 0638 0870 241 1320 0870 241 1321...