The First Years Remote Bottle Warmer Instruction Manual page 7

ACTIVATING THE WARMING CYCLE
From remote
Press and hold the remote button down
warming time
NOTE:
o While the unit is warming, the remote will pulse a soft orange glow so you know it
is warming.
o When warming cycle is complete, the remote will glow orange for 10 minutes
and the base unit LCD screen will display "00" and will be back lit in soft orange
 To shut off the lights (LCD screen and remote) prior to the auto shut off
time, press the power button for 2 seconds.
NOTE: After attempting to activate the warming cycle by remote,
programed to alert you to potential issues.
go to the base unit for problem solving. Potential solutions:
Remote battery level low
No water in water reservoir
Remote is out of range from the base unit
The base unit is not in standby mode
Expired Batteries
Base unit and remote are not paired
From base unit
Press the power button once to activate warming to the preset warming time
NOTE:
 The LCD screen on the base unit will show time remaining in the warming cycle.
The screen will pulse a soft glow during warming cycle.
 When complete the LCD screen will be a soft solid glow for 10 minutes
WARNING

ALWAYS swirl bottle contents/stir food well and test temperature of
contents before giving bottle to child.

ALWAYS use the lift-out basket when warming or sterilizing.
 When warming cycle has completed, the base unit will contain steam:
o Use caution when removing lid and/or removing bottle from the warmer.
o The lid may contain condensation, use caution removing/placing lid on
furniture
To cancel warming cycle:
Push down on the power button for 3 seconds to cancel warming. It is not
recommended to reheat formula or breastmilk - either serve or dispose of bottle
contents after canceling warming cycle.
for 2 seconds to activate
If you get such a response from the remote,
LCD Screen - flashing battery icon
Remote - When pushed to activate warming cycle, the warming cycle will
start and the remote will flashes orange/blue lights for 10 seconds then to
pulsing orange (then solid orange when warming is complete). While the
unit is in standby mode, the remote will flash orange every 10 minutes
LCD Screen - shows H2O
Remote – will flash alternating blue and orange lights
LCD Screen - normal setting allowed into standby
Remote - no lights when button is pushed
LCD Screen - blank
Remote - no lights when button is pushed
LCD Screen - flashing low battery icon
Remote - no lights when button is pushed
LCD Screen - normal setting allowed into standby
Remote - no lights when button is pushed
warming to the preset
the remote is
Page 7 of 9