Preparing The Remote - The First Years Remote Bottle Warmer Instruction Manual

PREPARING THE REMOTE

1. Remove battery door, using a phillips screw driver
2. Insert 4 AAA batteries (ref image)
3. Replace battery door
 Line drawing of the bottom of the remote showing a screwdriver unscrewing the door
 Line drawing of the inside of where the batteries go (showing positive and negative
outlines for clarity)
PAIRING THE REMOTE TO THE BASE UNIT
Pairing creates a coded signal so that only the remote's signal can remotely activate the
warmer. On occasion, the remote and base unit may need to be paired.
The base unit and remote are already paired coming out of the package. However,
should the connection between the base unit and remote be broken, it will need to be
paired again.
To pair the remote to the base unit:
1. Plug in the base unit and make sure there are charged batteries in the remote
2. With the base unit OFF, press and hold UP and DOWN button for 5 seconds
3. LCD will display "-P-" (when "-P" appears, release the UP/DOWN buttons)
4. Press the remote button
5. If pairing is successful, the blue and orange LED lights will flash 3 times on the
remote and the warmer will return to OFF state
NOTE: If no remote is paired in 1 min, the warmer goes back into OFF state.
The remote will have no lights. Repeat steps to attempt to pair.
TIP: Batteries may not installed correctly, no longer have a charge or are missing
Page 5 of 9