Table of Contents
Advertisement
ßè Server Connection
Terminal Connection Manager lists all the network connections available for
use. You Should go through the following steps in order to connect to the
server.
1. Select a Connection Name on the list.
2. Click "Connection" or double click "Connection Name". If the connection
has been defined as automatic logon, W150 is connected and you are
logged on automatically.
3. In case the logon is not automatic, Window Logon Information Window is
displayed. Enter logon with the prompt.
ßè Using of W150 Hot Keys
Hot keys are used to simplify the switching process between active sessions.
By using hot keys instead of Terminal Connection Manager, you can switch
automatically each program through simple key manipulation. In the below,
several W150 hot keys are specified as below.
< W150 Hot Keys >
Hot Key
CTRL+ALT+up arrow
CTRL+ALT+Down arrow
C T R L + A L T + H o m e
C T R L + A L T + E N D
< F 2 >
If the hot keys are not working, see the instruction of Multi Connection Start.
Multi Connection start
<
W150 can perform multi connections at the same time. The number of
connection is connections is limited by the RAM capacity.
1. Press CTRL+ALT+END to access to W150 Connection Manager.
2. Select Connection Name and then, click "Connect".
21
F u n c t i o n
Changes to Up between active sessions
Changes to Down between active sessions
Changes automatically to default sessions
The screen is changed to directly to W150
Connection Manager
The screen is changed to Terminal Preference Screen
in case Connection Manager is run.
>
Advertisement
Table of Contents
