Page 1
Eye 360 Led LED WASH This product manual contains important information about the safe installation and use of this projector. Please read and follow these instructions carefully and keep this manual in a safe place User manual Please read the instructions carefully before use...
1. Safety Instructions • Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet. • Unpack and check carefully there is no transportation damage before using the unit. •...
2. Installation Take 1 hook and 1 safety cord out from the package and x the hook on the chassis, and fasten the hook with the chassis to the underside of fixture with 2 screws, Hang the fixture on the structure and fasten the screws attached to the hook.
4. Operating Instructions • The moving head is for spot effect for on-site decoration purpose. • Don’t turn on the fixture if it’s been through severe temperature difference like after transportation because it might damage the light due to the environment changes. So make sure to operate the fixture until it is in normal temperature.
5. DMX-512 Control Connections Connection between controller and projector and between one projector and another must be made with a 2 core-screened cable, with each core having at least a 0.5mm diameter. Connection to and from the projector is via cannon 3 pin XLR plugs and sockets. The XLR's are connected as shown in the figure above.
6. Menu Setting DMX Start Address Each projector must be given a DMX start address, so that, the correct projector responds to the correct control signals. This DMX start address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the controller. The fixture have 3 DMX modes.
7. DMX Channels 18 Mode chanel Function Instruction 0-255 Tilt 0-255 Pan Fine 0-255 (16 bit) Tilt Fine 0-255 (16 bit) Motor Speed 0-255 From fast to slow Dimmer 0-255 (0-100% dimming) Shutter 0-255 Strobe Slow to fast (0 is open) 0-255 (linear) Green 0-255 (linear)
25 Mode chanel Function Instruction 0-255 Tilt 0-255 Pan Fine 0-255 (16 bit) Tilt Fine 0-255 (16 bit) Motor Speed 0-255 From fast to slow Dimmer 0-255 (0-100% dimming) Shutter 0-255 Strobe Slow to fast (0 is open) 0-255 (linear) Ring 1 Green 0-255 (linear) Ring 1 Blue...
It is definitely necessary to keep a projector clean for its reliable use. Cooling fans and their shield should be cleaned every 15days. LED lamps’ lens and cover should be cleaned regularly for optimized light output. Cleaning frequency depends on how often a projector is used and its operational environment. A soft cloth and typical glass cleaning products should be used.