Hardware Installation - ZLG PCIe-9140I User Manual

Guangzhou ZHIYUAN Electronics Co., Ltd.
Figure 2-1: Terminal resistor connection inside the communication card

2.4 Hardware Installation

The PCIe-9140I interface card is an electrostatic-sensitive product, and it is placed in a
special protective bag in the factory. Please take the necessary protective measures to
protect the interface card from the static damage caused by human body touch when
users use the interface card.
The PCIe-9140I interface card should be installed when the PC/IPC is powered off;
similarly, it should be removed when the PC/IPC is powered off.
The PCIe-9140I has no any switcher and jumper used to assign interrupts and I/O
addresses, which are assigned by BIOS automatically. So, the board card must be
installed into the PCI-E slot before install driver. The installation steps are as follows:
1. Switch off the PC and open the PC case.
2. Plug the PCIe-9140I interface card into the idle PCI-E slot (x1, x4, x8 or x16 slot).
3. Tighten the screws for mounting board card.
4. Switch on the PC and the BIOS inside PC will assign interrupts and I/O addresses to
PCIe-9140I interface card automatically.
5. Install driver.
User Manual
Date: 2017/10/09
High performance CAN card for PCIe interface
C
Figure 2-2: Select terminal resistor
5
PCIe-9140I User Manual
©2017 Guangzhou ZHIYUAN Electronics
V1.00