Silent Alert SW3A-2208-EU Quick Start Manual

Quick start guide SW3A-2208-EU
SignWave receiver
SignWave
CCM3A-2216-EU-PIR-MKX
MOVEMENT MONITOR 11/12/13
USE MAINS POWER SUPPLY
PS3A-2207-UK ONLY
SILENT ALERT SA3000 SYSTEM
WWW.SILENT-ALERT.CO.UK CLOFIELD LTD. UK
TEL 01246 260045
1.
3.
1
The SignWave should be left for 24 hours to fully charge. The unit should be placed on the base each night to recharge
2
3 4 5
& can be left on the base indefinitely if required. It can then be taken off the base and used as required.
ON /OFF
WARNING! Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children.
Cancel button
Event display
Volume control
ON /OFF
Strobe light
Front cover
Insert a small flat blade
screwdriver into the slot on
the front cover.
Push gently and the cover
will pivot outwards
Connect the power supply
to the SignWave base and
plug adaptor into a 13 Amp
mains socket.
Connect the pillow pad
(if required) at this stage.
If a pillow pad is not
required switch key B on the
SignWave to the left.
NOTE* If no VP is present
failure to switch key B ON
will result in a flashing
fault light
Receiving a signal
e p
When a signal is received the strobe will
B e
ON /OFF flash, a sound will be emitted and one of the
event lights will illuminate. This sequence
can be cancelled by pressing the cancel
button at the top of the unit.
If it is not cancelled with the button the
sequence will continue for 20 - 30 seconds
then cancel automatically.
Smoke and CO signals will sound for 15
minutes unless cancelled as required by
British standards.
Turn the control clockwise to increase
volume or anticlockwise to decrease.
Any questions? Call us on 01246 450789
2.
4.
3
2
1
ON /OFF
Silent
Alert
SignWave contacts
Pillow pad socket
Power supply socket
SignWave
Base Unit
Move the On /Off key to the
left using the edge of the
front cover.
Replace the front cover, the
SignWave will flash the
battery light green once
every 8 seconds to indicate
the unit is switched on.
Place the base on a smooth
surface such as a bedside or
coffee table.
ON /OFF
Dock the SignWave onto
the base.
The battery symbol will light
5
solid green to show the
SignWave is correctly docked
and charging.
4
5
Low Battery
When the SignWave has a
low battery the battery light
will flash orange.
The unit will beep, the strobe will
flash and the battery symbol will flash
4 times. This sequence will repeat
every 15 minutes until the SignWave
is placed on its charging base.
TM
4