Qualisports Volador Manual

This is a precision instruction, please make sure you read this carefully before you try your first ride. If
This is a precision instruction ,please make sure you read this carefully before you try your first ride.
you doubt about any information inside this instruction,please contact us or your local distributor .
If you doubt about any information inside this insturction,please contact us or your local distributer .
Paremeter
Product name: Ebike
Volador
Model name: QSEB02
Size: 1470*580*1120mm
Folded size: 820*370*680mm
Wheel base: 1007mm
Net weight: 17.5kg
36Ibs
Range: 50km
31miles (PAS )
Max. load: 100kg
220Ibs
Max. speed: 25km/h
20MPH
Charging time: 3 Hrs
Battery type: Samsung Lithium-ion
Battery capacity: 36V 5.2Ah/6.4Ah/7.0Ah
7.0Ah
Noise : ≤ 62 dB(A)
Fold your Ebike
②
①
⑥
MANUAL
Motor : MXUS 250W brushless geared DC motor
350W
Rated output power: 250W
350W
Motor efficiency: ≥80%
Rated RPM: 265±10r/min
Rated voltage: 36V
Max torque: 40N.m
Overcurrent protection: 12±1A
Low-voltage protection: 30±1V
Kwh: ≤1.2Kw.h
Modes: 5 levels
+ throttle + walk assist
Tire diameter: 20 inch
Frame: 20 inch 6061 Al-Alloy foldable
Front fork: 20 inch 6061 Al-Alloy
1. Hold firmly the seat post
(important), loosen the
clamp.
2. Push the seat post slowly
towards the ground, tighten
1. grab the seat post(impor
the seat post clamp.
tant). loose the clampe.
2. Push the seatpost till the
ground slowly,tight the
seatpost clamp.
⑤
5. Release the lock clamp
downwards, then fold the
head tube downwards.
6. Fold the pedal by
pushing it up.
5. release the lock clamp,
fold the head tube.
6. fold the pedal by pushing
it level.
Brakes: 160mm disc brakes
Rim: 20 inch Al-Alloy 13G36H
Tire: Kenda 20*1.95
Chain wheel: Prowheel 52T
Free wheel: Shimano 7 speed
Front hub: Sigma Al-Alloy
Chain: KMC
Handle bar: VELO
Promax
Display: Kunteng LCD
Controller: Kunteng sine wave FOC
Brake levers: Al-Alloy e-bike lever
Saddle: KNUS
Pedal: foldable pedals
③
④
⑦
⑧
3. Loosen the handle bar
clamp.
4. Turn the handlebar
clockwise until vertical, and
then tighten the clamp.
3. loose the handle bar
clamp.
4. turn the handlebar clockwise
till vertical ,tight the clamp.
7.Release the safety cap
upwards.
8.Pull the lock bar, fold the
main tube backwards.
7. release the safety cap.
8. pull the lock bar ,fold the
main tube.