Table of Contents
Advertisement
ADDING A DEVICE TO THE APP
The LED wifi strip has two different setup modes,
Quick Connection and AP (Access Point). The quick
connection is a quick and simple way to set the unit
up. The AP connection uses a direct local wifi
connection between your phone and the device to
upload the network details.
Before starting the setup, please ensure that your
device is in the correct standby mode for the
connection type you are attempting, the flashing of the
lights on your device will indicate this
Connection Type Frequency of Flashes
Quick Connection Flashes once per second
AP (Access Point) Flashes
FACTORY RESET / CHANGING CONNECTION
MODE
The unit can be reset by changing between the modes,
To change the mode turn power to the LED strip off
and on 3 times within 30 seconds, allowing the light to
turn on before turning back off each time.
i.e off-on-off-on-off-on
seconds
once
per
two
Advertisement
Table of Contents
