The electrical installation should provide a fuse or circuit breaker to protect the reed switch
from overloads.
When installing the connector, make sure that the cable gland (A) closes over the cable and that
the connector (B) with the rubber seal (C) is well screwed down to maintain the IP65 rating.
6
MAINTENANCE
No special maintenance is required.
7
TECHNICAL CHARACTERISTICS
Mounting:
Fluid density:
Working temperature:
Working pressure:
Body in AISI 316L:
Body in PTFE:
Connections:
Connector:
Electrical characteristics of the reed sensor:
Maximum switching power:
Maximum switching voltage:
Maximum switching current:
:
Hysteresis
Ingress protection:
Horizontal pipe or vertical
No restrictions
-40ºC ... +125ºC
PN25 (others on request)
PN10
G1 (1" NPT on request)
DIN 43650 A
5 W
120 VAC, 175 VDC
0,18 AAC, 0,25 ADC
±5% of paddle travel
IP65
7
pipe with upwards flow