Operation; Step 4 - Operating The Hoist - Hills Rotary Clothesline 37 Product Manual

Step 4 – Operating the Hoist
4.1 To adjust the height of your Rotary Hoist,
wind the handle and head assembly down
and then fit one or more of the plastic
spacers in the ground socket.
The suggested operating height is the
user's head height +25mm (1") (Fig. 4).
Note: The height adjusting winding
mechanism has an automatic device to
disengage the handle at the maximum and
minimum heights.
A slight 'clicking' noise will be heard when
this system is operating.
Fig. 4
Latch detail
Latch
Press to
release
Lower cross

Operation

4.2 To open: Undo the line tie-off cord.
(Refer to Step 6). Make sure the lines
are tangle free. Push the lower cross
and arms up until the latch engages.
4.3 To fold: Press the latch to release the
lower cross. Place your hands on the
arms and pull downwards.
4.4 Wrap and fasten the line tie-off cord
around the hoist to prevent lines from
becoming tangled.
4.5 To remove from the ground socket:
Unlock the locking collar by rotating
anti-clockwise. Lift the Rotary Hoist from
the ground socket and store in a suitable
place. Insert the cover into the top of the
ground socket.
Locking collar
Cover
Spacers
Ground socket
5