Advertisement
Installation
Mount on Solid Brick
2B
or Concrete Block
WARNING
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or "cinder block"), verify that the actual
concrete thickness is at least 35 mm (1-3/8") in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS!
Be sure to mount the assembled wall-mount plate with the included concrete anchors, D6 washers and anchor bolts onto
solid sections of the blocks. The solid sections can generally be found 25 mm (1") toward the middle of the block from
either end. An electric drill on a slow setting is suggested to drill the hole rather than a hammer drill so as to avoid
breaking out the back of the hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
Screw the
assembled wall
plate onto the
wall
5
60 mm
(2.4 in.)
O10 mm
O(3/8 in.)
Find and mark
Drill pilot holes
the exact
location of
mounting holes
Concrete
Anchor
20 mm
Washer
Anchor
Bolt
Advertisement
