Replace Battery In Panelview Plus 7 Performance Terminals, Panelview 5500 Terminals, Panelview 5510 Terminals, And Panelview 5310 Terminals - Allen-Bradley 2711P-RY2032 Installation Instructions Manual

Battery Replacement
Replace Battery in PanelView Plus 7 Performance Terminals,
PanelView 5500 Terminals, PanelView 5510 Terminals, and PanelView
5310 Terminals
IMPORTANT
Follow these steps to replace the battery in PanelView Plus 7 Performance terminals, PanelView
5500 terminals, PanelView 5510 terminals, and the PanelView 5310 terminals.
1. Disconnect power from the terminal.
2. Remove the screws that secure the logic module to the back of the display.
Logic Module
Display Module
3. Carefully lift the logic module away from the display module and turn over to expose the
circuit board.
4. Locate the coin-cell battery on the circuit board.
10 Rockwell Automation Publication 2711P-IN009J-EN-P - December 2017
Although the components of the PanelView Plus 7 Performance terminals, PanelView 5500 terminals,
PanelView 5510 terminals, and PanelView 5310 terminals may differ slightly, the procedure for replacing
the battery is the same for all four products.