Care And Maintenance - Black + Decker 1,000,000 POWER SERIES Instruction Manual

• Use in a dry location only.
• Except for the bulb, there are no user-serviceable parts inside. Do not attempt to disassemble any other parts
of the unit.
• To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting.
• Do not attempt to charge the unit if the 120 volt AC charger plug is damaged – return the unit to manufacturer
for repair.
SAVE THESE INSTRUCTIONS
INTRODUCTION
Thank you for choosing the Black & Decker
before use to ensure optimum performance and to avoid damage to the unit.
FEATURES
AREA LIGHT
ON/OFF BUTTON
RUBBER BEZEL
QUARTZ HALOGEN BULB
LED AREA LIGHTS
ON/OFF TRIGGER
CHARGING/RECHARGING THE LIGHT
This unit is shipped in a partially charged state. Charge unit after purchase and BEFORE first use using
the 120 volt AC charger until the green Battery Status LED Indicator LED lights (approximately 10
hours). Charge after each use.
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at least every 30
days.
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE:
• Never place the light face down on any surface when charging.
• Failure to keep the battery charged will cause permanent damage and result in poor performance.
Charging/Recharging Using the 120 Volt AC Charger and a Standard Household
Extension Cord (not included)
HOUSEHOLD EXTENSION CORD
(NOT INCLUDED)
• Make sure the Spotlight is OFF (the Trigger Lock is in the OFF position and the Trigger is not depressed).
• Lift the AC charger cover located at the back of the unit and connect a standard North American 120 volt AC
extension cord to the 120 Volt AC Charger. Plug the other end of the cord into a standard 120-volt AC wall
outlet.
• Charge for one additional hour after the green Charge Status LED Indicator lights (approximately 10 hours).
VEC157BD_VEC157BDC_ManualENSP_012216.indd 4-5
Rechargeable Spotlight. Please read this guide carefully
®
EASY GRIP HANDLE
BATTERY STATUS LED
INDICATOR
BUILT-IN 120 VOLT AC
CHARGER (BACK OF UNIT)
TRIGGER LOCK
PISTOL GRIP HANDLE
BATTERY STATUS LED
INDICATORS
BUILT-IN 120V AC
CHARGER
4
OPERATING INSTRUCTIONS
Operating the Spotlight
1. Disconnect from charger.
2. The ON/OFF trigger is located in the front of the pistol-grip handle of the spotlight.
3. To turn the spotlight ON, squeeze the trigger.
4. To turn OFF the spotlight, release the trigger.
Note:
The ON/OFF trigger can be locked in the ON position using the trigger lock ON switch on the side of the unit.
Operating the LED Area Lights
The ON/OFF pushbutton for the LED Area Lights is located on the top of the Spotlight.
IMPORTANT: The Battery Status LED Indicators will not light when the spotlight is turned on. The Battery
Status LED Indicators will light when the LED Area Lights are operated. (When all three battery status LEDs
light, it indicates a full battery. Only one red battery status indicator light indicates that the unit needs to be
recharged.)

CARE AND MAINTENANCE

All batteries lose charge with time, especially when they are warm. Recharge the unit every 30 days
when not in frequent use, preferably using the 120 volt AC method.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a
soft cloth moistened with a mild solution of water and detergent.
The quartz halogen bulb is the only user-replaceable part in the Spotlight. Periodically inspect the condition of
cords, connectors and wires. Contact Technical Support toll-free at 1-877-571-2391 to replace any components
that have become worn or broken.
Spotlight Bulb Replacement
IMPORTANT: Before proceeding with bulb replacement, check the filament to determine if the bulb needs
to be replaced.
To replace the bulb, you will need a small Phillips screwdriver and a 6 volt H3 75 watt replacement bulb. During
installation, avoid touching the glass part of the bulb. Bulb life may be shortened by installing a bulb with dirt or
fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol.
QUARTZ HALOGEN
BULB
RETAINING RING
RUBBER BEZEL COVER
TRIGGER
TRIGGER LOCK
RUBBER
END CAP
TRIGGER
REFLECTOR
SWITCH
RUBBER
TRIGGER
"O" RING
(OFF) LOCK
5
1/22/2016 10:47:58 AM