Supplied Accessories; Quick Reference; Attaching The Stand - Sharp Aquos LC-40C37U Operation Manual

Supplied accessories

Make sure the following accessories are provided with the product.
Remote control unit ( g 1)
Page 8
Cable Clamp ( g 1)
Page 7
NOTE
• Always use the AC cord supplied with the TV.

QUICK REFERENCE

Attaching the stand

• Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on.
This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• The "REAR" label should be visible from the back of the TV. Refer to
the figure.
• Incorrect installation of the stand may result in the TV falling over.
• Be sure to follow the instructions.
1. Confirm the 8 screws supplied with the TV.
Short screws ( m 4)
(used in step 2)
Attach the two parts of the stand unit to each other using
2.
the 4 short screws and the hex key (supplied with the
product) as shown.
Short screw
NOTE
• To detach the stand, perform the steps in reverse order.
6
"AAA" size battery ( g 2)
Page 8
Cable tie ( g 1)
Page 7
Long screws ( m 4)
(used in step 3)
Hex key
Stand unit ( g 1)
Page 6
REAR
This side faces the rear.
3.
1 Insert the stand into the opening on the bottom of the
TV.
2 Insert and tighten the 4 long screws into the 4 holes on
the rear of the TV.
2
Soft cushion
1
AC cord ( g 1)
Page 7
Operation manual ( g 1)
Hex key
Long screw