Watching Tv; Turning On/Off The Power; Initial Setup; Tv Location - Sharp LC-32SB24U Operation Manual

Watching TV
Press POWER on the TV or on the remote control unit to turn the
_ '_' '_ ..... poweron.
POWER indicator (Green): The %/is on (After a few seconds, a window
appears with sound)
POWER _X_
The initial setup starts when the TV powers on for the first time, If the TV has
been turned on before, the E7 Setup will not be invoked See page 20 for
performing E7 Setup from the Setup menu,
Press POWER on the TV or on the remote control unit again to turn the
POWER power off.
(On/Standby) • The _V enters standby and the image on the screen disappears.
The POWER indicator on the TV turns off
_DTJ
If you are not going to use this TV for a long period of time, be sure to remove
the AC cord from the AC outlet,
® Weak electric power is still consumed even when the TV is turned off
When you turn on the TV for the fist time, it will Air/Cable (Antenna setting}
automatically memorize the broadcasting channels Make sure what kind of connection is made with your %/
available in the region where you live. Perform the when selecting "Air" or "Cable"
following steps before you press POWER on the 3 Press _/_ to select "Air" or "Cable"
remote control unit. Press ENTER to enter the setting
1. Insertthe batteries intothe remote control unit (See page 8) Example
2, Connect the antenna cable to the TV (See page 8,)
g, Plug in the AC cord to the AC outlet (See page 7 )
Language (Language setting}
Select from among 3 languages: English, French and Spanish,
"_ Press A/1F to select the deshed language listed on the
screen, and then press ENTER
CN Search (Channel search}
Channel auto search makes the _V look for all channels
viewable in the set area.
4
When "Air" is selected in Antenna setting:
Press _i/_ to select "Start", and then press ENTER
]3/Location
Select "Home" or "Store" for the location where you plan to
install the %/,
2 Press 4/_ to select "Home" or "Store"
Press ENTER to enter the setting
Example
When "Cable" is selected in Antenna setting:
Press A/_" to select "Analog & Digital Search Start" to
search both analog and digital broadcasts, or to select
"Analog Search Start>'to search only analog broadcasts,
and then press ENTER,
• if you select "Home", AV MODE is set to "STANDARD"
If you select "Store", AV MODE is set to "DYNAMIC (Fixed)".
In case no remote control signal is received within 80 minutes,
r-
AV MODE will change to "DYNAM b(Fked)" automatically
• For changing the %/Location after the setting, see "EZ
Setup" on page 20
The Channel search will start automatically,
To exit the Channel search screen, select "Cancel", and
then press ENTER
If no channel is found, confirm the type of connection made
with your TV and t/y EZ Setup again
(See page 20)
12