Table of Contents
Advertisement
Connecting Indoor Unit Electrical Wiring for HSV3 Units, continued
5. When done, reattach the bottom panel to the indoor unit, being careful to align panel using the rear tabs.
6. Using a screwdriver, reattach the screws to the bottom panel and secure.
7. Once screws are in place, re-snap the latches over the screws.
• If all other piping and electrical wiring to the outside unit has been completed at this stage, the system can be turned on for testing.
• If piping connections are not completed,
and wiring to the system.
Appearances may vary depending on Indoor Unit Model.
Figure 97: Indoor Unit Knockout (Communication Wires)
ELECTRICAL SYSTEM INSTALLATION
do not turn power on at this time. Proceed to complete all other piping, (along with drain hose)
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Indoor Unit Electrical Connections
Figure 98: Indoor Unit Terminal Block with Grounding Cable
(Example Only)
55
Hide quick links:
Advertisement
Table of Contents
