Related Manuals for Tanaka BS2-80TS
Summary of Contents for Tanaka BS2-80TS
- Page 1 Model BS2-80TS Instruction Manual Read this manual thoroughly before using the product, and store in a safe place for future reference. TANAKA SCIENTIFIC LTD, TOKYO, JAPAN - 1 -...
-
Page 2: Section Name And Functions
１ Section Name and Functions Paper Cutter Power LED Power Source Input Error LED Cover Opening Button Power Switch Feed Button Screw Hole DIP Switch Left: SW2 Right: SW3 Battery Compartment Lid Power Switch: Turn the power ON/OFF FEED Button: Push this button to feed roll paper. Cover Opening Button: Push this to open the cover when you replace roll paper. - Page 3 ２ Paper and Battery Setting ! Warning: Do not set battery wrong position. Battery may burst. Paper Cover Cover Opening Button. Push cover opening button to open the cover. Insert thermal paper to the printer by 1 direction. Pull out the edge of the paper 2 direction, then confirm that the paper is set straight. Note: loose of roll paper may cause jam.
-
Page 4: Dip Switch Settings
No.2 ４ Connection to Tanaka Testers 1. Change/confirm the baud rate of TANAKA Tester to 9600 bps. See each tester’s Maintenance Manual. 2. Connect the printer and tester’s control unit with supplied RS-232C connecting cable. 3. Connect the plug of AC adapter to the printer, and then plug in the AC adapter to an electric outlet. -
Page 5: Specification
５ Specification Printing method Direct line thermal Number of dots 448dots/line Printing/ Paper width 63mm/80mm Interface RS-232C (2400 to 115200bps) Interface RS-232C Input buffer 8 k bytes Power source AC adapter: DC7.5V 3.0A (Model: BS-100W) Dry cell battery (AA size): 4 Alkaline batteries Current consumption 4.0A max.