ECHO BARRIER H-SERIES User Manual page 8

Installing Echo Barrier Panels
Provided the supporting structure is of sufficient height and
strength to support the Echo Barrier panels, the panels can
be attached to:
„ Fencing
„ Chain-link fencing
„ Site hoardings (using drilled holes and fixing cables)
„ Scaffold tubes
„ Trusses
„ Beams
Security
To minimize the risk of theft or damage through graffiti,
Echo Barrier panels should be installed on the inner side
(Figure 5) of any structure to which the public might have
direct access.
Figure 5. Panel Security
Anti-Theft Cable
Security cables (Figure 6) can be used to padlock the
Echo Barrier panels to the supporting structure.
PAGE 8 — ECHO BARRIER • USER MANUAL — REV. #0 (09/14/18)
INSTALLATION GUIDE
Figure 6. Security Cable
Fixing Points
The existing eyelets (Figure 7) should serve as the sole
fixing points for the Echo Barrier panels. You should not
attempt to pierce any additional holes in the panels.
Figure 7. Eyelet
The eyelets at the top left-hand and right-hand corners
are the principal fixing points of each Echo Barrier panel.
The central eyelet can be used for further securing the
Echo Barrier panel to the supporting structure. It can also
be used as a mid-fixing point if a panel is:
• straddling two supporting structures;
• being folded around a corner; or
• being installed horizontally.
The fixings in Echo Barrier fitting kits, or generic cable-ties,
can be used for the central eyelets.