Table of Contents
Advertisement
TRANSPORTATION INSTRUCTIONS
1.The appliance should be transported only in an upright position. The packing as supplied
must be intact during transportation.
2.If during the course of transport the appliance has to be transported horizontally, it must
only be laid on its left hand side when standing in the front of the appliance. After bringing it
to upright position,it must not be operated for at least 4 hours to allow the system to settle.
3.Failure to comply with the above instructions could result in damage to the appliance, for
which the manufacturer will not be held liable.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
5. When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the door or handle.
6. Empty any water in the drain tray before moving. See section „Defrosting" and „Care &
cleaning" for further information.
7. Make sure that the defrost water pipe at the back of the product is fixed to the plastic
evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.
Important!
Care must be taken while cleaning/carrying the appliance not to touch the bottom of the
!
condenser metal wires at the back of the appliance, as this could cause injury to fingers and
hands.
Do not attempt to sit or stand on top of your appliance as it is not designed for such use.
!
You could injure yourself or damage the appliance.
Make sure that the mains cable is not caught under the appliance during and after moving,
!
as this could damage the cable.
Do not allow children to play with the appliance or tamper with the controls.
!
BEKO
plc declines to accept any liability should the instructions not be followed.
AETCS – Advanced Electronic Temperature Control System
Your Fridge Freezer is equipped with AETCS, the latest innovation from Beko Engineers,
which features the following benefits;
Accurate and consistent temperature maintenance for improved performance thanks to
!
advanced electronics used in the control system.
The system in the electronics monitors the ambient temperature and controls the
!
compressor to make sure that the freezer will work in ambient temperatures down to -15°C.
This means you can install your appliance, if required, in a garage or similar outside
locations where there is no heating. Because the fridge would be too cold, food may be
affected, such as salad and fruit. So make sure you don't leave such food in the fridge in
very cold ambient conditions.
Because in cold conditions, the appliance works less, it would also save on electricity costs.
!
INSTALLATION INSTRUCTIONS
1.
The space in the room where the appliance is installed must not be smaller than 10 cubic
metres.
2.
Do not place the appliance near cookers, radiators or in direct sunlight as this
will cause your appliance to work harder. If installed next to a source of heat or freezer,
maintain the following minimum side clearances:
From Cookers
From Radiators
From Refrigerators or Larder Fridge
2" (50 mm)
12" (300 mm)
1" (25 mm)
4
Hide quick links:
Advertisement
Table of Contents
