Sound Volume; Changing Channels; To Adjust The Volume - Sharp LC 20SH3U Operation Manual

Basic Operation (Continued)

Sound Volume

■ To adjust the volume

● Press VOL (+) to increase the sound volume.
The bar indicator shifts right.
VOLUME
50
● Press VOL (–) to decrease the sound volume.
The bar indicator shifts left.
VOLUME
10
■ To mute the sound
● Press MUTE to temporarily turn off the sound.
The MUTE mark
● Press MUTE or VOL (+)/(–) to turn the sound back to the
previous level.
The mute function is automatically turned off when any of
the following buttons are pressed: POWER, MUTE,
VOL (+)/(–) or MTS.
VOLUME
10
A
• When VOL (+)/(–) is pressed in the Mute mode, the sound turns
on and the volume indicator is displayed.
• The Mute function is canceled when POWER is pressed.
■ To select MTS (Multichannel TV Sound)
1
Press MTS to display the MTS screen.
2
Press MTS to select the MTS settings.
STEREO: stereo audio
SAP: secondary audio program
MONO: monophonic audio
<
STEREO ON A I R
<
SAP ON A I R
MONO
A
• "ON AIR" appears when a STEREO or SAP broadcast is being
aired.
is displayed for 4 seconds.

Changing Channels

You can select channels using Channel Select or
CH ( )/( ).
• This LCD TV set allows you to select up to 125 channels
(1 to 125). To select a channel, enter a 2- or 3-digit number.
■
Using Channel Select
When selecting the channel using Channel Select, complete
input of the channel number by holding down the button for
the last digit for a moment.
To select a 1- or 2-digit channel number (e.g., Channel 5):
Complete the following procedure within 4 seconds.
1
Press the button.
0 –
A
• When selecting a 1-digit channel number, do not fail to press the
button first.
To select a 3-digit channel number (e.g., Channel 115):
Complete the following procedure within 4 seconds.
1
Press the button.
1 – –
3
Press the button.
1 1 5
A
• The 3-digit channel number can be selected only when the
receiving mode is set to CABLE in CH-SETTING.
Changing channels with CH (
Air: Press CH ( ) and the channels change in the order shown below:
2 → 3 → . . . → 68 → 69 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 69 → 68 → . . . → 3 → 2 → . . .
Cable: Press CH ( ) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 125 →1 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 1 → 125 → . . . → 3 → 2 → 1 → . . .
■ Using FLASHBACK
● Press FLASHBACK to switch the currently tuned channel
to the previously tuned channel.
● Press FLASHBACK again to switch back to the currently
tuned channel.
2
Press the button.
5
2
Press the button.
1 1 –
)/( ) on the remote control