Care And Cleaning Of Architectural Metals - ThyssenKrupp TAC 32 Owner's Manual

Owner's Manual
Listed below are suggested care and cleaning instructions
and typical products for use by building owners. Any cleaning
The use of chloride-containing cleaners must be avoided.
Surfae damage will occur from the use of such cleaners.
Routine cleaning with a mild dishwasher liquid will remove
fingerprints, smears and everyday liquids such as soda,
coffee and other beverages. Consumer type glass cleaners
Only routine care and cleaning is recommended. The surface
should be waxed weekly with paste wax (or more often
depending on building traffic). This puts a protective coating
of wax over the lacquer and reduces scuffing. Do not use any
abrasives or chemical cleaners. This type of product will
Routine cleaning with a mild detergent, soap and water will
remove fingerprints, smears and everyday type liquid spills
E2010 THYSSENKRUPP ELEVATOR

Care and Cleaning of Architectural Metals

#4 Brushed and #7 or #8 Mirror Finished Stainless Steel
#4 Brushed and #7 or #8 Mirror Finished Muntz (Bronze)
ThyssenKrupp Baked Enamel Finishes
Technical Information-5
or refinishing, other than routine, should be handled by
qualified professions.
are also effective on fingerprints and beverage spills and a
good stainless steel cleaner can also be used. Do not use
abrasives such as scouring powders. Always finish with a light
rinse of warm clean water.
cause damage. Recommended cleaning is to remove spills,
smears and fingerprints with a soft cloth dampened with plain
tap water. If this recommendation is not followed, early failure
of the coating will occur.
such as coffee or soda. Do not use any abrasive powders or
harsh chemicals.
Printed in USA February, 2010