Advertisement
Quick Links
Garage Door Opener Radio Controls
Model 5040 (300 mHz) \ 5042 (310 mHz) Single Button Mini Transmitters
Model 5050 (300 mHz) \ 5052 (310 mHz) Dual Button Mini Transmitters
• • Disconnect operator power before any installation or repair
• • Always wear safety glasses
Your Digi-Code radio controls are designed specifically to remotely control a garage
door opener and to give years of trouble free service without adjustment. Because all
radio controls are set with the even numbered switches in the "ON" position when
they leave the factory, it is recommended that a different code be selected and set at
the time of installation. Please refer to the "Setting the Code Switch" section for
instructions. The radio frequency (RF) portion of the controls, however, are tuned to
standard frequencies and are thoroughly tested at the factory. This permits the addition or
replacement of either the transmitter or the receiver by specifying the Model number and
the RF frequency designated on the identification label. RF adjustments are not needed
nor should any be attempted.
ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT
The models 5040, 5042, 5050 & 5052 mini transmitter cases are made up of two halves
which are held together by a small phillips head screw. Removing this screw will allow
access to the code switches and the battery compartment ( see diagram #1 ).
Installation Instructions
WARNING:
SECTION #1
( Diagram #1 )
Advertisement
Related Manuals for Digi-Code 5040
Summary of Contents for Digi-Code 5040
-
Page 1: Installation Instructions
SECTION #1 ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT The models 5040, 5042, 5050 & 5052 mini transmitter cases are made up of two halves which are held together by a small phillips head screw. Removing this screw will allow access to the code switches and the battery compartment ( see diagram #1 ). - Page 2 SETTING THE CODE SWITCHES ON THE MODEL’S 5040 AND MODEL 5042 SINGLE BUTTON MINI TRANSMITTERS Use your finger to slide the “code switch hatch” from the Digi-Code receiver or locate the code switches on the back of your Stanley operator. The digital code is determined by the position of the 10 small switches numbered 1 through 10 located in the receiver and the transmitter ( see diagram #2 ).
- Page 3 MODEL 5050 AND MODEL 5052 DUAL BUTTON MINI TRANSMITTERS Use your finger to slide the “code switch hatch” from the Digi-Code receiver or locate the code switches on the back of your Stanley operator . On the transmitter, locate the phillips head screw on the bottom of the case, removing this screw will allow access to the code switches and the battery compartment ( see diagram # 4 &...
-
Page 4: Transmitter Battery Replacement
SETTING RECEIVER #1 (WORKS WITH LEFT BUTTON ON TRANSMITTER) Use your finger to slide the “code switch hatch” from the Digi-Code receiver or locate the code switches on the back of your Stanley operator. Set the receiver code switch positions 1 through 9 to match the transmitter code switch. -
Page 5: Operational Check
CAUTION: Any changes or modifications in intentional or unintentional radiators which are not expressly approved by Digi-Code Inc. could void the users authority to operate this equipment. This applies to intentional and intentional radiators certified per part 15 of the FCC rules and regulations.