Digi-Code 5040 Installation Instructions Manual page 3

Garage door opener radio controls
Table of Contents

Advertisement

SETTING THE ( "RECEIVER" ) CODE SWITCHES - TO WORK WITH
MODEL 5050 AND MODEL 5052 DUAL BUTTON MINI TRANSMITTERS
Use your finger to slide the "code switch hatch" from the Digi-Code receiver or locate
the code switches on the back of your Stanley operator . On the transmitter, locate the
phillips head screw on the bottom of the case, removing this screw will allow access to
the code switches and the battery compartment ( see diagram # 4 & # 5 ).
Model – 5050 (300mHz) or 5052 (310mHz)
Before setting the receiver code switches, you will need to set the transmitter code switch
on your model 5050 or 5052. We strongly suggest that you change the code from the
factory setting to provide security for your own system, and to eliminate interference with
neighboring systems.
SECTION #3
( Diagram # 4 )
( Diagram # 5 )

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5040 and is the answer not in the manual?

This manual is also suitable for:

505050425052

Table of Contents