Advertisement
SETTING THE TRANSMITTER CODE SWITCH – MODEL'S 5050 & 5052
On the transmitter, locate the phillips head screw on the bottom of the case, removing this
screw will allow access to the code switches and the battery compartment . Once you
have done this, locate the code switch and set code switch positions 1 through 9 to your
personal code scheme ( THE 10
CLOSED POSITION "ON"), (Note: The switch is in the "on" position when it is
depressed toward the number.). We strongly urge that several coding schemes be
avoided: ALL ON; 2,4,6,8,10, ON. These positions are similar to our or other
manufacturers test positions, or are frequently used.
SETTING RECEIVER #1 (WORKS WITH LEFT BUTTON ON TRANSMITTER)
Use your finger to slide the "code switch hatch" from the Digi-Code receiver or locate
the code switches on the back of your Stanley operator. Set the receiver code switch
positions 1 through 9 to match the transmitter code switch. Then make sure that the
th
10
position switch on receiver #1 is set in the closed position "ON". The left button
on the transmitter should now operate this receiver.
Once the codes have been set, check operation and reassemble products.
SETTING RECEIVER #2 (WORKS WITH RIGHT BUTTON ON TRANSMITTER)
Use your finger to slide the "code switch hatch" from the Digi-Code receiver or locate
the code switches on the back of your Stanley operator. Set the receiver code switch
positions 1 through 9 to match the transmitter code switch. Then make sure that the
th
10
position switch on receiver #1 is set in the open position "OFF". The right button
on the transmitter should now operate this receiver.
Once the codes have been set, check operation and reassemble products.
TRANSMITTER BATTERY REPLACEMENT
The battery in the transmitter can be checked or changed by locating the phillips head
screw on the bottom of the case, removing this screw will allow access to the battery
compartment. Replacement battery must be a 12-volt.
TO REPLACE OR ADD A SET
A replacement or new transmitter or receiver may be purchased by specifying the Model
Number and the RF frequency designated on the serial tag label. The RF frequency is set
at the factory and must not be adjusted in the field. The digital code can be matched to
the companion receiver or transmitter by following the "setting" procedures above.
TH
POSITION SWITCH MUST BE SET IN THE
SECTION #4
Advertisement
