Initial Setup - Sharp Aquos LC 26D7U Operation Manual

Watching TV

Initial setup

When you turn on the TV for the first time, it will automatically memorize the broadcasting channels where you
live. Perform the following steps before you press TV POWER on the remote control unit.
1. Insert the batteries into the remote control unit. (See page 7.)
2. Connect the antenna cable to the TV. (See page 16.)
3. Plug in the AC cord to the AC outlet. (See page 6.)
1
Language setting
Select from among 3 languages: English,
French and Spanish.
Press a/b to select the desired language
listed on the screen, and then press ENTER.
2
Standby Mode setting
Select the standby setting. (See page 42.)
Language
Standby Mode
TV Guide On Screen
Air/Cable
CH Search
Mode 1: Starting TV is quick from standby.
Mode 2: Power consumption is small at the standby.
NOTE
• When the CableCARD is inserted, power consumption will
be higher.
3
TV Guide On Screen setting
Press ENTER to continue the setting. (See page
20.)
4
Antenna setting
Make sure what kind of connection is made with
your TV.
Press c/d to select "Air", "Cable" for ANALOG, then
press b to move down.
Press c/d to select "Standard", "HRC" or "IRC" for
DIGITAL (Cable).
Press ENTER to enter the setting.
• There are 3 kinds of CATV system, including Standard,
HRC and IRC. Select the one that matches to your TV.
NOTE
• Some items are not selectable because the antenna
setting is linked to the TV Guide On Screen setting.
• DIGITAL(Cable) setting cannot be selected when a proper
CableCARD is inserted.
18
5
Press c/d to select "Yes" for ANALOG, then press b
to move down.
Press c/d to select "Yes" for DIGITAL (Air), then press
b to move down.
Press c/d to select "Yes" for DIGITAL (Cable), and
press b to move down.
Select "Search Start", and then press ENTER.
• This operation makes the TV search for both ANALOG,
DIGITAL (Air) and DIGITAL (Cable) channels.
Mode 1
Language
Standby Mode
Mode 2
TV Guide On Screen
Air/Cable
CH Search
Example
CH Search
ANALOG
CH Search
DIGITAL
CH Search
DIGITAL
• Make sure what kind of connection is made with your TV.
• If no channel is found, make sure what kind of connection
is made with your TV and try EZ setup again. (See page
39.)
Channel search
Channel auto search makes the TV look for
all channels viewable in the set area.
ANALOG Yes
DIGITAL (Air) Yes
DIGITAL (Cable) Yes
Search Start
Air [ 25 ] Found
Air [ 25 ] Found
Cable [ 25 ] Found
Air ANALOG
2
Audio : MONO
NOTE
No
No
No
[ 20 ]
[ 20 ]
[ 25 ]