Connecting A Pc; Viewing An Image From A Pc; Displaying An Image From A Pc - Sharp Aquos LC 20D30U Operation Manual

Connecting a PC

Viewing an Image from a PC

Use the INPUT5 (PC-IN) terminals to connect a PC.
A
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 39 for a list of PC signals compatible with the System.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with
the PC. (See pages 38 and 39.)
• Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to
your PC's manuals regarding converting to external output.
PC
To Audio output
terminal
Signal names for 15-pin mini D-sub connecter
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11

Displaying an Image from a PC

To ANALOG
To ANALOG RGB
RGB terminal
output terminal
RGB cable (supplied)
ø 3.5 mm stereo minijack cable
(commercially available)
Connecting the RGB cable
Ferrite core
Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 CSYNC
A
• Pin No. 5 is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
To view an image from a PC, perform the following procedure.
1 Select the INPUT5 (PC) mode using INPUT on the remote control or the LCD TV set. (See
page 18.)
2 Select the PC input signal. (See page 38.)
3 Adjust the "FINE SYNC." items if the PC image does not come in clearly. (See page 38.)
To AUDIO
input terminal
• Connect the RGB cable making sure
• Do not remove ferrite cores attached
Pin No. Signal name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
+ 5V
9
0 GND (Ground)
that it fits correctly into the terminal.
Then, firmly secure the connectors
by tightening the screws on both
sides of the plug.
to the RGB cable.
Pin No. Signal name
q Not connected
w SDA
e HD
r VD
t SCL
37