Page 2
For more information regarding trademarks, see the "Trademark Notices" section of this manual. ACR Systems Inc. assumes no responsibility for errors or omissions, or for damages resulting from the use of information contained in this document or from the use of programs and source code that may accompany it.
Page 3
TRADEMARK NOTICES TrendReader is a Registered Trademark of ACR Systems Inc.
Page 4
LIMITED WARRANTY ACR Systems Inc. warrants the hardware to be free from defects in workmanship and components provided they are not abused or subjected to detrimental conditions. Refer to the warranty information included with your logger for details. Software is warranted for one year from the date of purchase, to operate in accordance with its programmed instructions.
Page 6
For important information on how TRH-1000 data loggers work and how to use them, read the Introduction to TRH-1000 chapter. It will give you an overview of how the loggers work and how to configure them for your application. Next, read the chapter that...
They can also start logging at a specified time. Self-powered by a long-life lithium battery that will provide years of reliable operation, your TRH-1000 can work independently from any external power supply or computer. When you are ready to look at the data it has collected, you can transfer all information to your computer through the use of TrendReader software.
Each TRH-1000 data logger has an on-board temperature and relative humidity sensor that you can use to record ambient temperature and relative humidity. TRH-1000 data loggers can store readings to memory using one of two sampling methods: 1. First-in, First-out (FIFO). In this method the logger continues to take readings when its memory is full (to make room, it discards the oldest reading every time it adds a new one).
TRH Data Loggers TRH Software Driver TrendReader software uses a software driver to communicate with TRH-1000 data loggers. The software driver takes the form of two windows. The Status window, shown when you contact the logger, is used to display the settings currently stored in the data logger. The Setup window, shown when you select Edit Setup, is used to alter the current settings and apply the changes to the data logger.
Page 15
TRH Data Loggers Full. Currently there is no compression method available for TRH-1000 loggers. To set when the logger will start recording click on the Start Time field. Next, click on the small button that appears at the right. This will pop up a form allowing you to set the date and time.
To set each calibration value, click on the appropriate calibration field and enter the value. The factory equations for the TRH-1000 use the Low and Mid values as offset and span. High and Ext are not used.
TRH Data Loggers TRH-1000 Temperature & Relative Humidity Logger A self-contained "air-quality" logger, the TRH-1000 can be used easily in a wide variety of applications to collect temperature and relative humidity data. 1.3.1 Description The TRH-1000 is a low-cost, easy-to-use temperature and relative humidity data logger. With its precision calibrated internal temperature and relative humidity sensor, simply place the logger in the field and leave it to record.
1.3.4 Relative Humidity Calibration If your TRH-1000 is supplied with a calibration certificate it will include calibration values. These calibration values must be entered in and stored in the logger. If your RH sensor is out of calibration check these values against the values in the logger to make sure they are the same.
Minutes and Seconds columns list the time spans over which your logger will record readings at each sample rate. For example, a TRH-1000 using a sample rate of ten minutes will store readings for 226 days and 16 hours. After that time, depending on how it was set up, the logger will either continue to take readings and replace the oldest readings with the new readings (FIFO), or it will stop taking readings (Stop When Full).