Jr-1000/1001 Software Driver - ACR Systems JR-1000 Reference Manual

1.2

JR-1000/1001 Software Driver

TrendReader software uses a software driver to communicate with JR-1000/1001 data
loggers. The software driver takes the form of two windows. The Status window, shown when
you contact the logger, is used to display the settings currently stored in the data logger. The
Setup window, shown when you select Edit Setup, is used to alter the current settings and
apply the changes to the data logger. The settings are divided into two main sections:
and Channels. Status contains information about sampling, memory and logger description.
The channel of the logger contains information about the channel type (temperature), equation
and Realtime value, and calibration associated with the channel. You can control the level of
detail that you see for the settings by clicking on the "+" and "-" buttons at the left side to
expand and collapse the nodes.
When you want to clear the logger's memory and start a new logging session with the existing
or new parameters, select Edit Setup from TrendReader. In the Edit Logger Setup window,
make any necessary changes. To implement your changes, you can either click on Apply or
OK. OK will implement the changes and close the window whereas Apply will leave the
window open, thereby allowing you to make changes in other features.
Copyright © 2010 ACR Systems Inc. All Rights Reserved.
JR-1000/1001 Data Loggers
7
Status