Download Print this page

Dytran 1051C Operating Manual

Charge mode dynamic force sensor

OG1051C.DOC 12-20-00

Rev A, ECN 9708, 03/06/13

Rev B, ECN 12897, 08/18/16

D y n a m i c T r a n s d u c e r s a n d S y s t e m s

2 1 5 9 2 M a r i l l a S t . • C h a t s w o r t h , C A 9 1 3 1 1 • P h o n e 8 1 8 - 7 0 0 - 7 8 1 8

w w w . d y t r a n . c o m • e - m a i l : i n f o @ d y t r a n . c o m

OPERATING GUIDE

MODEL 1051C

CHARGE MODE DYNAMIC FORCE SENSOR

This manual contains:

1) Outline/Installation drawing 127-1051C

2) Operating Instructions Model 1051C

Table of Contents

Need help?

Do you have a question about the 1051C and is the answer not in the manual?

Page 1 . d y t r a n . c o m • e - m a i l : i n f o @ d y t r a n . c o m OG1051C.DOC 12-20-00 Rev A, ECN 9708, 03/06/13 Rev B, ECN 12897, 08/18/16 OPERATING GUIDE MODEL 1051C CHARGE MODE DYNAMIC FORCE SENSOR This manual contains: 1) Outline/Installation drawing 127-1051C 2) Operating Instructions Model 1051C...
Page 2 The very thin quartz crysta als comprise a a relatively he 1051C for rce sensor is d designed to small portion of the length of the sensor r which measure c...
Page 3: Installation
(top surface of the force plus standardization to the miniature in-line types sensor). Thread this cap securely into the tapped 4751 and 4705 which adapt the 1051C to LIVM hole in the platen, again inspecting for foreign operation with constant current power units.
Page 4: Operation
DC Figure 3 is intended to illustrate the right and bias is blocked within the power unit. the wrong way to apply loads to the 1051C. Obviously we cannot address the many different Consult the factory for the low frequency...
Page 5: Maintenance And Repair
QUASI-STATIC CONSIDERATIONS Close to DC measurements are possible with the 1051C when used with a laboratory type charge amplifier such as the model 4165. These force sensors are calibrated at the factory by placing a traceable compressive force on them, (with a...