Advertisement
6.
Replacement parts and accessories. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty.
7.
Do not operate product if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there
is any doubt, do not operate the product.
8.
Always use a solid object to push food into the Meat Grinder/Food Mincer. Never use
your hands as this may result in serious harm and injury.
9.
Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts.
Wear restrictive hair coverning to contain long hair. Keep hands and fingers away from moving
parts.
Warning:
Your Meat Grinder/Food Mincer will require some assembly prior to use. It is important that you
read the entire manual to become familiar with the product BEFORE you use the Meat Grinder/
Food Mincer. Before assembling the Meat Grinder/Food Mincer be sure that you have all parts
described in the Parts List and Assemby Diagram located on the last page of this manual.
Step 1)
The Shaft Case (#3) is set into the small diameter hole at Handle (#1) end. Slide the
Axis (#4) into the Shaft Case (#3).
Step 2)
Place the Steel Blade (#5) onto the end of the Axis (#4). Caution: Be careful of the
sharp blade when handling it.
Step 3)
Choose the Cutting Die that best suits your needs. Use either the Broad Cutting
Die (#6) for regular grinding or mincing, or the Fine Cutting Die (#7) for narrower
grinds or cuts.
Step 4)
Set either the Broad Cutting Die (#6) or Fine Cutting Die (#7) so that the four (4) tabs
in each rest on the outside of the discharge chute.
Step 5)
Twist on the Front Cover (#8). Tighten securely to secure assembly in place.
Step 6)
Slide Container (#2) with assembly onto Base (#10). Place Key (#11) onto Lock
Button (#9). Turn Key (#11) on Lock Button (#9) to the right to activate the suction
lock and secure the Base to the counter or working area. Turn the Key (#11) on Lock
Button (#9) to the left to release the suction lock on Base (#10).
Step 7 )
Insert Handle (#1) into Shaft Case (#3).
Caution: To avoid health hazards: Before assembling, thoroughly clean all unassembled Meat
Grinder/Food Mincer parts in a dishwasher. When cleaning, use a mild anti-bacterial detergent.
Clean the Meat Grinder/Food Mincer after every operation. Failure to follow these precautions may
result in serious illness due to food poisoning.
#03716
The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be
supplied by the operator.
Assembly
Page 3
Advertisement
