Focon Showtechnic Expolite led22385 User Manual page 28

Miscellaneous Settings
MENU
PERSON SET
The default password is: UP - DOWN - UP - DOWN - ENTER
UPLD: sends the user programs to connected slave fixtures.
REST: sets all editable settings back to factory default.
COLR: in this submenu a colour calibration is selected or deactivated. When RGBW is
selected, the maximum brightness values at DMX = 255 are limited to the values set in CAL2.
When UC is selected the Uniform-Colour factory calibration is used, which adjusts devices of
different generations. If the value is set OFF, the calibration is deactivated and the device reaches
the maximum brightness.
DIM: controls different dimming speeds to simulate a halogen bulb (DIM4/DIM3/DIM2/DIM1/OFF).
DERR: sets how the fixture responses if DMX-signal gets lost. Set SAVE to hold the last
received value or BLAC for blackout.
ZOOM: in this menu the standard start position (POS1), end position (POS2) and the home position
(BASE) of the motorised zoom are set.
CURV: In curve menu, the dimmercurves are set as shown below.
CURV dimming
(100%)
1
2
HSIC UPLD
HSIC REST
HSIC COLR
HSIC DIM
HSIC DERR
HSIC ZOOM
HSIC CURV
1: OFF
2: CV1
3
3: CV2
4
4: CV3
SEND
****
REST
****
OFF
RGBW
UC
DIM4
DIM1
DIM2
DIM3
OFF
SAVE
BLAC
P(0 - 255)
BASE
POS.1 P(0 - 255)
P(0 - 255)
POS.2
OFF
CV 1
CV 2
CV 3
E-28