Service Connections - Cleveland Steamcraft II Service Manual

Table of Contents

Cleveland Range Company equipment is designed and built to comply with applicable standards for manufacturers. Included among

those certification agencies which have approved the safety of the equipment design and construction are: UL. A.G A., NSF, ASME,

CSA, CGA, and others.

Cleveland Range Company equipment is designed and certified for safe operation only when permanently installed in accordance with

local and/or national codes. Many local codes exist, and it is the responsibility of the owner and installer to comply with the

In no event shall Cleveland Range Company assume any liability for consequential damage or injury resulting from installations which

are not in strict compliance with our installation instructions. Specifically, the Cleveland Range Company will not assume any liability

for damage or injury resulting from improper installation of equipment, including, but not limited to. temporary or mobile installations

Ref. No.

Qty.

Description

Ground lug for ground w connection

terminal block for feed wire connection

Feedwire knockout hole—

Fuse holders with 2 amp type KTKR-2

fuses (Part No 06344)

Drawn plumbing

Venting outlets—No connections or re-

strictions should be made

ELECTRICAL

Install in accordance with local codes and/or the National Electric Code ANSI/NFPA No 70-1984 (USA) or the Canadian Electri-

cal Code CSA Standard C22.1 (Canada). A separate fused disconnect switch must be supplied and installed. The steamer must be

eiectncally grounded by the installer.

The electric supply must match the power requirements specified on the steamer's rating label. The copper wiring must be

adequate to carry the required current at the rated voltage.

Locate the terminal block cover and "knock-out" plug at the upper left corner of the steamer's back panel. Remove the two screws

securing the terminal block cover and remove the cover. Remove the "knock-out" plug. Feed permanent copper wiring through the

"knock-out." and fasten to the terminal block, in accordance with the wiring diagram affixed to the steamer's back panel. Be sure

to connect the ground wire to the separate ground terminal connecfor (ground lug). Replace the terminal block cover and secure it

with the two screws.

The steamer is— wired for 3-phase delta operation at the facfory. For single phase operation, the installer must change the

Two jumpers on the terminal block to that shown in the accompanying diagram (and on the steamer's wiring diagram label.)

two jumpers on the terminal block to that shown in the accompanying diagram (and on the steamer's winng diagram label)

1 PHASE

AMPS AWG

VOLTS

Watts

206

5000

220

4202

240

5000

410

WATER

A 1/4" * IPS COLD water line is required. DO NOT USE HOT WATER. Minimum water pressure is 35 psi (2 4 kg/cm2), the

maximum water pressure is 60 psi (4.1 kg/cm2), measuring flow pressure, not static pressure Connect the cold water line to the

input side of the line strainer, located on the outside of the steamer's back panel, toward the top-center of the panel Refer to the

service connection drawing for precise location.

RECOMMENDED PLUMBING (furnished by the installer):

Shut-off Valve' The water supply can be shut off at this valve in the event that the steamer, or a plumbing component, requires service