Table of Contents
Advertisement
1.
Insert the other 15-pin signal cable connector into the 15-pin VGA connection on
your computer and screw it down.
2.
Plug the power cord connection to connection on the monitor.
3.
Plug the other end of the power cord to your computer's main supply or to a
100V-240V earthed electrical outlet.
4.
Turn on the monitor using the power switch and check that the power LED is on.
If not, repeat steps 1,2,3 and 4 or refer to the Troubleshooting section of this
guide.
5.
Turn on the power to the computer. The picture will appear within about 10
seconds. Adjust the picture to obtain optimum picture quality. See section
Adjusting the picture in this guide for more information.
USB hub
The USB hub have 1 upstream port and 4 downstream ports. The upstream port can
be connected to the root hub of host PC or other downstream port. Four(4)
downstream ports allow to connect another USB device such as USB mouse, joystick,
printer etc.
LED Indicator
Power Switch
USB 4 downstream ports
5
Advertisement
Table of Contents
