Instructions Before Installation; Installing The Wireless Magnet Contact Switch - Dometic MagicSafe RRC90 Installation And Operating Manual

RRC90
6

Instructions before installation

Supplementary to fig. 3
I
NOTE
If you do not have sufficient technical knowledge for installing and connecting
components in vehicles, you should have a specialist install it for you.
The wireless receiver is suitable for vehicles with a 12 V power supply.
6.1 Determining the installation location for the receiver control unit
See fig. 4
Select an installation location for the control unit near the control module of the alarm system:
• In the vehicle interior
• Not in areas where strong electrical fields could cause interference, e.g. ignition cables or
central control electronics
• Not in the immediate vicinity of other control units, to prevent the devices from interfering
with each other (which could cause malfunctions and reduce the range of the radio remote
control)
• Not directly next to ventilator nozzles.
7

Installing the wireless magnet contact switch

See fig. 5
Observe the following installation instructions:
• Install the wireless magnetic contact switch in the interior of the vehicle.
• The interval between the magnet (3) and sensor (1) must not exceed 12 mm.
• Align the sensor so that the LED (2) points away from the magnet (3).
➤ Tightly fasten the magnet (3) to the door, to the stowage compartment lid or to the window.
➤ Screw the sensor (1) to a fixed component (e.g. door or window frame).
➤ Test whether the interval is small enough:
When you open the doors, the LED (2) must light up once briefly.
I
NOTE
For securing windows, use the wireless window contact switch (ref. no. 9600000381).
The wireless window contact switch must be installed on the window frame so that the
contact is pressed down when the window is closed.
EN
Instructions before installation
5