Page 1
Acu-Tech EF300 Electrofusion Welder Manual EF300 & EF300GPS New technology has led to the development of a generation of HDPE welding products that boasts an array of unique and revolutionary features. The EF300 Pressure Welder has been designed and built by a reputable company in Germany, with the low weight and compact dimensions not compromising the top- notch performance ability and unconditional reliability.
Page 2
The product must not be sprayed with or immersed in water. Opening the Unit Caution: The cover of the product may be removed only by Acu-Tech Piping Systems personnel, or of a partner organization properly trained and approved by the manufacturer.
Page 3
2. Connecting the Electrofusion Fitting Connect the connection terminals to the fitting and check for proper fit. The contact surfaces of the connection terminals and the fitting have to be clean. Dirty terminals may lead to improper welding and also to overheated and fused terminal plugs. After the fitting was connected, the yellow LED (Fitting connected) lights up.
Page 4
4. Overvoltage ( The input voltage is above 280 volts. Adjust generator output voltage. 5. Temperature Error or Temperature Sensor Defective ( The measured ambient temperature is outside the operating range of the welding unit, i.e., below – 5°C or over + 40°C.
Page 5
The manufacturer recommends having the product serviced at least every twelve months. Service and Repair Contact Acu-Tech Piping Systems 119 Kelvin Rd, Maddington, Western Australia, 6109. 1300 270 270 www.acu-tech.com.au...