Section 3 Operator Console; Alphanumeric Display; Keypad - Raychem C910-485 Installation, Operation And Maintenance Manual

Section 3 OPERATOR CONSOLE

3.1 ALPHANUMERIC DISPLAY

The console incorporates a six characters, fourteen segment, plus decimal LED display.
Messages and prompts that are greater than six characters long are scrolled, allowing
more meaningful, non-cryptic messages to be used.

3.2 KEYPAD

The local keypad consists of six keys that allow you to select the console mode function
that you are interested in. For certain keys, the SHIFT key selects an alternate function, as
shown by the text above that key. When connected to the ACS-30 control system, the key
pad is locked out and will display "Remote Control".
Figure 3.1 – Keypad
Key Function
SHIFT Press to activate a shifted function; the next key pressed uses the
alternate (shifted) function (ALARM, MONITOR and CONFIG).
The SHIFT LED illuminates, indicating the next key uses the alternate
(shifted) function.
Pressing SHIFT again cancels the alternate (shifted) function.
TEST Turns on heating cable circuit for 30 seconds.
SHIFT + TEST Switches the console to the Alarm/reset mode.
BACK Exits the current menu (or cancels the new setting when editing a
parameter)
Moves the cursor to the left when editing an alphanumeric
parameter.
[SHIFT + MONITOR] Switches the console to the Monitor mode.
ENTER Selects the item in the display (or accepts the setting when editing a
parameter).
Moves the cursor to the right when editing an alphanumeric
parameter.
[shift + CONFIG] Switches the console to the CONFIG mode.
Moves to the previous item in a menu.
Increments the value when editing.
Moves to the next item in a menu.
Decrements the value when editing.
Up/Down Arrow Once the main menu has been entered, use the Up/down arrow keys
Keys to navigate the program options.
nVent.com | 14