Writing Of Sales Data - Sharp TINSZ2600RCZZ Instruction Manual

Writing and reading all the programming data
You can write all the programming data in the cash register onto an SD memory card (Writing). The existing
programming data in the card will all be replaced with the newly written data at this time.
You can also replace the programming data stored in the cash register with those stored in an SD memory card
by loading the latter into the cash register (Reading).
Set the mode switch to the PGM position.
Writing
s
Reading
s
* The message "
When writing or reading is finalized, the message "SD FINAL" will be printed. In case an error occurs, a
corresponding error message will be printed.

Writing of Sales Data

7
Write all of the existing sales data (daily and periodic totals) into an SD memory card. You can write the data into
the same card a maximum of 400 times unless the card becomes full.
Set the mode switch to the X1/Z1 position.
650
* The message "
writing is finalized, the message "SD FINAL" will be printed. In case an error occurs, a corresponding error
message will be printed.
66
141
147
" will appear and stay on the display until all data is completely written or read.
P
" will appear and stay on the display until all data is completely written. When
The comfirmation message is printed.
@ s
The comfirmation message is printed.
@ s
The comfirmation message is printed.
@ s
To execute
*
1 A
l
To cancel
To execute
*
1 A
l
To cancel
To execute
*
1 A
l
To cancel