Renaming A Disk; Erasing A Disk; Renaming A Disk Pool; Legacy Disks - Edge DiskGO Installation Manual

3270 Ver406-06)
and to replace the disk. To view the disks that are available, select the Show Disk Details
check box.

Renaming a Disk

1. On the Disk Management - Basic page, select the Show Disk Details
check box, and then click Rename Disk.
2. In the Old Disk Name list, click the name of the disk that you want to
rename.
3. Type the new name in the New Disk Name box.
4. Click Rename Disk.

Erasing a Disk

The Erase Disk function erases the data on a disk. When you wipe a disk, ensure that all
the pools in the target disk that span multiple disks have either been deleted or that these
companion disks are also being wiped at the same time. If this condition is not met, an
error is the result.
To erase disks
1. Select the Show Disk Details check box, and then click Erase Disk.
2. Select the respective check boxes for the disks to be included in the wipe
operation.
3. Click Quick Erase to remove only the control information from the disk.
Click Full Erase to completely erase all the data from the disk.
Notes:
• The Full Erase process is very slow; the amount of time required for a full erase
depends on the size of the disk.
• For the full erase operation to proceed, you must type Yes, destroy everything on this
disk in the Confirmation String box.

Renaming a Disk Pool

1. On the Disk Management - Basic page, click Rename Pool.
2. In the Old Pool Name list, click the name of the pool that you want to
rename.
3. Type the name of the new pool in the New Pool Name box.
4. Click Rename Pool.

LEGACY DISKS

The Legacy Disks page displays information about any attached legacy disks. Before you
remove a legacy disk, click Safely Remove Disk. To return to the Legacy Disk
Management page, click Continue .

CREATE NEW POOL

To create a new pool within the DiskGO 3.5" Network Hard Drive, open the Create New
Pool page located within the Disk Management menu and follow the steps below. This
15