Crime Guard 328i3 Installation Manual page 8

in two sides- the "ignition switch" side and the "starter solenoid" side. It is
recommended that this connection be made as close to the ignition switch as
possible. Use a voltmeter, not a test light, to find the correct wire, which is
the wire from the ignition switch to the starter solenoid.
CAUTION! Avoid the airbag circuit! Improper use of a test light can cause
deployment of the airbag, which may result in bodily injury! Test lights can
also damage on-board computers and associated sensors.
Typical Dash-Mounted Ignition Switch
Showing Starter Disable Connections
Dash-
mounted
Ignition
Switch
The starter wire will read Positive 12 Volts only when ignition key is in
"start" position (cranking the engine). Cut this wire at a suitable location.
Confirm that this is the correct wire by turning the ignition switch to the
"start" position. The starter should not engage Connect the starter disable
socket's Red wire to the ignition switch side. Connect the starter disable
socket's White wire to the starter solenoid side. Be sure that good, solid
electrical connections are made as this generally is a high amperage circuit.
Starter Disable Red
wire to the Ignition
Switch side of the
cut wire.
Starter Disable White
wire to the
Starter Solenoid
side of the cut
wire.
Page - 8
5-Pin
Connector
Relay
Starter
Socket
Disable
Orange
Socket
wire
Starter
Motor
Control
Module
Starter
Solenoid